Raymarine autopilot + ST4000+ - Manual (Page 61)

46 ST4000+ Wheel & Tiller Autopilots: Owner’s Handbook
5
Install
ing
the
ST4000+
EMC installation guidelines
All Raymarine equipment and accessories are designed to the best
industry standards for use in the recreational marine environment.
Their design and manufacture conforms to the appropriate
Electromagnetic Compatibility (EMC) standards, but correct
installation is required to ensure that performance is not
compromised.
Although every effort has been taken to ensure that they will perform
under all conditions, it is important to understand what factors could
affect the operation of the product.
The guidelines given here describe the conditions for optimum EMC
performance, but it is recognized that it may not be possible to meet
all of these conditions in all situations. To ensure the best possible
conditions for EMC performance within the constraints imposed by
any location, always ensure the maximum separation possible
between different items of electrical equipment.
For optimum EMC performance, it is recommended that wherever
possible:
D5439-1
Wheel drive parts
Clamp screw,
M5 x 16 mm (x6)
Wheel drive
Pedestal bracket
Spoke clamp (x3)
16 mm spoke
clamp insert (x3) 12 mm spoke
clamp insert (x3)
6 mm
drill bit
3 mm
allen key
4 mm
drill bit
Power cable
4.5 m (15 ft)
Bracket screw,
No 10 x 3/4 in (x4)
Cable clip
and screw,
No 6 x 1/2 in
Optional: Bulkhead/box pedestal fitting kit E15017 (if required) D5439-2
Wheel drive parts
Clamp screw,
M5 x 16 mm (x6)
Wheel drive
Pedestal bracket
Spoke clamp (x3)
16 mm spoke
clamp insert (x3)
12 mm spoke
clamp insert (x3)
6 mm
drill bit
3 mm
allen key
4 mm
drill bit
Power cable
4.5 m (15 ft)
Bracket screw,
No 10 x 3/4 in (x4)
Cable clip
and screw,
No 6 x 1/2 in
Optional: Bulkhead/box pedestal fitting kit E15017 (if required)