2 control unit, Location, Control unit – Raymarine autopilot + ST4000+ User Manual

Page 63

Advertising
background image

48

ST4000+ Wheel & Tiller Autopilots: Owner’s Handbook

5

Install

ing

the

ST4000+

5.2 Control unit

Location

Locate the ST4000+ control unit so it is:

within easy reach from the steering position

viewable straight on, or with a maximum viewing angle of 30°

protected from physical damage

at least 230 mm (9 in) from any compass

at least 1 m (3 ft) from any radio/radar receivers/transmitters

The selected location should also:

be clean, smooth and flat

be accessible from behind (so you can secure and run cables)

have sufficient space to accommodate the rear of the control unit
and connectors

allow at least 6 mm (

1

/

4

in) between adjacent control units and

instruments so you can fit their sun covers

CAUTION:

The ST4000+ front cover is waterproof when installed according
to the following instructions. However, the rear cover must be
protected from water in a ventilated and drained area. Any water
or water vapor in this area could cause damage by coming into
contact with electrical connections or condensation by entering
the control unit through its breathing hole.

110 mm (4.33 in)

11

5 mm (4.53 in)

90 mm (3.55 in)

24 mm

(0.95 in)

17 mm

(0.67 in)

D3242-2

Control unit dimensions

Advertising