Raritan Engineering KX2-864 - Manual (Page 153)

Chapter 7: Device Management
144
Removing Power Associations
Do not physically remove a power strip from the Dominion KX II without
first removing the power strip association in Device Settings. When a
target has been associated with a power strip and the target is removed
from the Dominion KX II, the power association remains. When this
occurs, you are not able to access the Port Configuration for that
disconnected target server in Device Settings so that the power
association can be properly remove.
To remove a power strip association:
1. Select the appropriate power strip from the Power Strip Name
drop-down list.
2. For that power strip, select the appropriate outlet from the Outlet
Name drop-down list.
3. From the Outlet Name drop-down list, select None.
4. Click OK. That power strip/outlet association is removed and a
confirmation message is displayed.
To remove a power strip association if the power strip has been
removed from the target:
1. Click Device Settings > Port Configuration and then click on the
active target.
2. Associate the active target to the disconnected power port. This will
break the disconnected target's power association.
3. Finally, associate the active target to the correct power port.