Raritan Engineering KX2-864 - Manual (Page 172)

Chapter 7: Device Management
163
Blade chassis Connection method Recommended CIM(s)
IBM BladeCenter E The current model BladeCenter E chassis
(8677-3Rx) ships standard with one Advanced
Management Module.
Source: IBM BladeCenter Products and
Technology
•
DCIM-USBG2
•
D2CIM-DVUSB
IBM BladeCenter T The BladeCenter T chassis ships standard with
one Advanced Management Module.
In contrast to the standard BladeCenter
chassis, the KVM module and the
Management Module in the BladeCenter T
chassis are separate components. The front of
the Management Module only features the
LEDs for displaying status. All Ethernet and
KVM connections are fed through to the rear to
the LAN and KVM modules.
The KVM module is a hot swap module at the
rear of the chassis providing two PS/2
connectors for keyboard and mouse, a
systems-status panel, and a HD-15 video
connector.
Source: IBM BladeCenter Products and
Technology
•
DCIM-PS2
IBM BladeCenter HT The BladeCenter HT chassis ships standard
with one Advanced Management Module. This
module provides the ability to manage the
chassis as well as providing the local KVM
function.
Source: IBM BladeCenter Products and
Technology
•
DCIM-USBG2
Required and Recommended Blade Chassis Configurations
This table contains information on limitations and constraints that apply
to configuring blade chassis to work with the Dominion KX II. Raritan
recommends that all of the information below is followed.