Rear panel – Roland SONAR V-STUDIO VS-100 User Manual

Page 15

Advertising
background image

15

Panel Descriptions

fig.rear01.eps

4.

Cord hook

Hook the AC adapter’s cord here, see p. 38.

5.

Power switch

Turn the power on/off. For more information, see p. 40.

6.

DC IN jack

Connect the DC plug of the supplied AC adaptor here.

7.

USB connector

Use a USB cable to connect the V-STUDIO 100 to a personal

computer.

8.

MIDI connectors (MIDI OUT/V-LINK and MIDI IN)

When the SONAR V-STUDIO 100 is connected to a computer,

these connectors work as 1 in/1 out USB MIDI interfaces.

When the SONAR V-STUDIO 100 is not connected to a

computer, the MIDI OUT connector becomes a MIDI output

connector for V-LINK.

9.

Footswitch connector

Connect a footswitch (sold separately) here.

You can use a footswitch to control the WAVE recorder

function or start and stop SONAR VS.

For more information about footswitch, see

“Connecting

footswitches”

(p. 46).

10.

Grounding terminal

Depending on the circumstances of a particular setup, you

may experience a discomforting sensation, or perceive that

the surface feels gritty to the touch when you touch this

device, microphones connected to it, or the metal portions of

other objects, such as guitars. This is due to an infinitesimal

electrical charge, which is absolutely harmless. However, if

you are concerned about this, connect the ground terminal

(see figure) with an external ground. When the unit is

grounded, a slight hum may occur, depending on the

particulars of your installation. If you are unsure of the

connection method, contact the nearest Roland Service

Center, or an authorized Roland distributor, as listed on the

“Information” page.

Unsuitable places for connection

• Water pipes (may result in shock or electrocution)

• Gas pipes (may result in fire or explosion)

• Telephone-line ground or lightning rod (may be

dangerous in the event of lightning)

Rear panel

* This product is equipped with balanced (XLR/TRS) type

jacks. Wiring diagrams for these jacks are shown below.

Make connections after first checking the wiring

diagrams of other equipment you intend to connect.

1: GND

2: HOT

3: COLD

TIP:

HOT

RING:

COLD

SLEEVE: GND

VS-100_r_e.book 15 ページ 2009年3月25日 水曜日 午前9時34分

Advertising
This manual is related to the following products: