Roland SONAR V-STUDIO VS-100 - Manual (Page 27)

27
Using the WAVE recorder
Information displayed on the main screen
fig.recorder02.eps
1. File name
2. Level meter
• Displays the output level
• When input signal was detected, displays the
input level
3. Marker view
• Number on the left: the number of the marker that was passed at the point displayed on the time counter
• Number on the right: the number of markers contained in the file
4. File length:
• while recording, this displays the remaining recording time
5. Time counter
• During playback and while paused: displays elapsed time since the beginning of the file
• During recording: displays elapsed recording time
fig.recorder03.eps
1. Display the main screen
2. Adjust the output level of the WAVE recorder
3. [A<>B] (repeat A-B) button
Play back the section between two points (A-B)
in the file repeatedly.
Set the A and B marks during playback to repeat
the section between A and B.
For more information, see “Loop playback (A-B
REPEAT)” (p. 33).
4. [METRONOME] button
Turn on the metronome. For more information,
see “Using the metronome” (p. 34).
5. [MARKER] button
Insert a marker at the point displayed on the time counter.
6. Reset the time counter to zero
If markers have been inserted, pressing this button will reset the time counter to the point of the previous marker.
7. Rewind the time counter
8. Fast-forward the time counter
9. Move the time counter to the end of the file
If markers have been inserted, pressing this button will move the time counter to the point of the next marker.
10. Stop
11. Start the playback from the point displayed on the time counter
12. Create a new file and start recording
Basic operation
VS-100_r_e.book 27 ページ ２００９年３月２５日 水曜日 午前９時３４分