Roland SONAR V-STUDIO VS-100 - Manual (Page 18)

18
Panel Descriptions
fig.02.eps
5. Compressor/equalizer setting button
Use this button to switch the display on the setting screen
between the compressor and the equalizer when using these
effects.
For more information about using the compressors and
equalizers, see “Using the compressors and equalizers” (p.
48).
6. [THRES/LO]/[R1] knob, [RATIO/MID]/[R2] knob and
[GAIN/HI]/[R3] knob
The functions of these knobs depend on the status of the
SONAR V-STUDIO 100.
• When the equalizer setting screen is displayed
Use these knobs to change each parameter of the equalizer.
(See “Setting the equalizers” (p. 49).)
• When the compressor setting screen is displayed
Use these knobs to change each parameter of the
compressor. (See “Setting the compressors” (p. 50))
• When the ACT function is on (only when SONAR is in use: see
“ACT section” (p. 23))
Use these knobs to control the plug-ins for SONAR and the
ACT function.
7. [ACT]/[V-LINK] button
When you are using SONAR, this button is the [ACT] button.
When you press this button, it lights up and you can use the
[R1]–[R4] knobs to control the plug-ins for SONAR and the
ACT function.
If SONAR V-STUDIO 100 is not connected to a computer, this
button becomes the [V-LINK] button. (See p. 57)
8. Display screen
This screen displays a range of information. When you press
the [DISPLAY] button, the level meter screen is displayed.
Level meter screen
fig.lvl-meter.eps
1. The input level of each INPUT
INPUT 1/2 shows the level after the signal passes through
the [SENS] knob.
2. USB audio (OUT 1/2) playback level
3. WAVE recorder playback level
4. MAIN OUT 1/2 output level
5. Peak indicator
Use the level knobs to adjust each level to ensure this
peak indicator is not lit.
9. [CURSOR/VALUE]/[R4] knob
Use this knob to move the cursor on the display or change
the value of the parameter. Push the knob ([SELECT] button)
to fix the value.
When the ACT function is on, this knob controls the plug-ins
for SONAR and the ACT function.
10. [DISPLAY] button
Press this button to display the level meter screen.
Press and hold the [DISPLAY] button for about 1 second to
display the system screen. On this screen you can change the
system settings of SONAR V-STUDIO 100. For more
information, see p. 52.
System section
VS-100_r_e.book 18 ページ ２００９年３月２５日 水曜日 午前９時３４分