Roland SONAR V-STUDIO VS-100 - Manual (Page 22)

22
fig.daw02.eps
This section controls playback of SONAR.
1. [LOOP] button
Press this button to turn SONAR’s loop function on or
off.
* This button is not lit even when SONAR’s loop function is
on.
[SHIFT] + [LOOP] buttons
Use this key combination to set the selected range for
SONAR’s loop function.
* For more information about selecting the range, see the
separate SONAR online help.
2. [VIEW] button
Press this button to display SONAR’s Track view.
[SHIFT] + [VIEW] buttons
Use this key combination to display SONAR’s Console
view.
3. [MARKER] button
Press this button to insert a marker at the current time.
* If you press this button while SONAR is paused, the
Marker view is displayed.
4. Button
Press this button to move the current time to the
beginning of the project.
[SHIFT] + button
Use this key combination to move the current time to
the previous marker.
5. Button
Press this button to rewind the current time.
[SHIFT] + button
Use this key combination to move the current time to
the previous measure.
6. Button
Press this button to fast-forward the current time.
[SHIFT] + button
Use this key combination to move the current time to
the next measure.
7. Button
Press this button to move the current time to the end of
the project.
[SHIFT] + button
Use this key combination to move the current time to
the next marker.
8. Button
Press this button to stop the transport.
9. Button
Press this button to start playback.
If you press this button during playback, the playback
pauses.
10. Button
Press this button to start recording tracks that are in
recording standby mode.
If you press this button during playback, you can start
recording tracks that are in recording standby mode
without stopping playback.
Transport section
VS-100_r_e.book 22 ページ ２００９年３月２５日 水曜日 午前９時３４分