Roland SONAR V-STUDIO VS-100 - Manual (Page 33)

33
Using the WAVE recorder
This function allows you to play back any section (A-B) in the file repeatedly. After inserting marks A and B while the
file is playing you can then repeat the section between the two marks.
fig.repeat-a.eps
1. Play back the file.
Press the [A <> B] button once during playback.
The [A <> B] button flashes. This point becomes the starting point (A mark) for the
playback loop.
* After inserting the A mark, pressing the (Stop) button before setting the
B mark cancels the A mark.
fig.repeat-b.eps
2. Press the [A <> B] button again.
The [A <> B] button lights up. This point becomes the end point (B mark) for the
playback loop.
The section set in the steps 1 and 2 automatically plays back repeatedly.
fig.repeat-ab.eps
* After inserting the A mark, if you play back to the end of the file without setting the
B mark, the end of file becomes the B mark.
Canceling the loop playback
To cancel the loop playback after inserting A and B marks, press the [A <> B] button.
The [A <> B] button turns off and the loop playback is cancelled.
Loop playback (A-B REPEAT)
A
A B
A B
VS-100_r_e.book 33 ページ ２００９年３月２５日 水曜日 午前９時３４分