Input, Output, Playback] knob – Roland SONAR V-STUDIO VS-100 User Manual

Page 16

Advertising
background image

16

Panel Descriptions

INPUT

fig.rear02.eps

11.

INPUT 3L/MONO and 4R (1/4” TRS balanced input)

Analog audio signal input jacks for line input. If you only plug

into one INPUT 3L/MONO jack, it will function as a mono

input.

These inputs correspond to input 3-4 in the USB audio

interface function.

12.

INPUT 5L and 6R (RCA pin input)

Analog audio signal input jacks for line input. These inputs

correspond to input 5-6 in the USB audio interface function.

13.

COAXIAL IN (7/8) (coaxial digital input)

A digital input terminal that supports S/PDIF.

This terminal supports 24-bit/96kHz digital signals.

These inputs correspond to input 7-8 in the USB audio

interface function.

* If you connect the SONAR V-STUDIO 100 to a computer, you

must match the sampling frequency of the input signal to

that of the SONAR V-STUDIO 100. For more information

about setting the sampling frequency, see

“Sampling

frequency setting”

(p. 52).

14.

Phantom power switch

This switch supplies phantom power to the INPUT 1L and

INPUT 2R XLR terminals.

* You must only turn on this switch if connecting a

microphone that needs phantom power. Supplying phantom

power to dynamic microphones or audio reproducing

equipment may cause a failure. For more information about

the specifications of your microphone, see its manual.

* Phantom power supply of SONAR V-STUDIO 100:

DC 48 V, 5 mA maximum per channel

OUTPUT

fig.rear03.eps

15.

MAIN OUTPUT 1 and 2 (1/4” TRS balanced output)

Analog audio signal output jacks

These outputs deliver the signals of the MAIN MIX, WAVE

recorder and USB audio playback (OUT 1/2) from the mixer.

16.

OUTPUT 3 and 4 (1/4” TRS balanced output)

Analog audio signal output jacks.

These outputs deliver the signal from USB audio OUT 3/4.

17.

OUTPUT 5L and 6R (RCA pin output jack)

Analog audio signal output jacks

These outputs deliver the signal from the USB audio OUT 5/6.

[PLAYBACK] knob

fig.playbackKnob.eps

Use this knob to adjust the volume of the USB audio playback

(OUT 1/2) that is output from the MAIN OUTPUT 1/2 and the

headphone terminal.

VS-100_r_e.book 16 ページ 2009年3月25日 水曜日 午前9時34分

Advertising
This manual is related to the following products: