Roland SONAR V-STUDIO VS-100 - Manual (Page 53)

53
System settings
The digital mixer section provides reverb that can be applied
to the signal from each input.
When you execute the system setting “Reverb” (p. 55), the
reverb screen appears, allowing you to specify the reverb
type and adjust the send levels for each input.
fig.SetRev1.eps
If reverb is on, the “Rv” icon is shown at the left of the
level meter screen. If reverb is being applied to a
channel, that channel number will be highlighted.
fig.SetRev2.eps
To initialize the settings to their factory-set state, proceed as
follows.
The LCD contrast, sampling frequency, digital input
settings, and the data in the SD memory card will not be
initialized.
1. Hold down the [DISPLAY] button for approximately
one second to access the system setting screen.
2. Turn the [CURSOR/VALUE] knob to move the cursor
to “Initialize,” and then press the [CURSOR/VALUE]
knob.
fig.Init1.eps
3. A confirmation screen appears.
To execute initialization, turn the [CURSOR/VALUE] knob to
highlight “Yes,” and then press the [CURSOR/VALUE] knob.
fig.Init2.eps
If you decide not to initialize, turn the [CURSOR/VALUE] knob
to highlight “No,” and then press the [CURSOR/VALUE] knob.
4. When initialization is completed, you will return to
the system setting screen.
5. Press the [DISPLAY] button to return to the
previous screen.
Reverb settings
Parameter Value
Type
ECHO, ROOM, SMALL HALL,
LARGE HALL
SEND LEVEL
Adjust the amount of reverb
applied to each channel
Initialization
Initializing the settings
VS-100_r_e.book 53 ページ ２００９年３月２５日 水曜日 午前９時３４分