Ricoh CL3000DN - Manual (Page 26)

Paper and Other Media
22
2
Loading Paper
R CAUTION:
Loading Paper in Tray
1/Optional Paper Feed Unit
AAAA
Pull the paper tray out of the
printer until it stops. After that,
lift it slightly, and then pull it out
completely. Place it on a flat sur-
face.
Note
❒ You can not pull Tray 1 out if
the Bypass Tray is open.
BBBB
Press "Push", and then adjust the
rear guide to the paper size you
want to load.
CCCC
Adjust the side guides to the pa-
per size you want to load.
DDDD
Load paper into the paper tray
with the print side up.
Important
❒ Make sure that the top of the
stack is not higher than the limit
mark inside the tray.
❒ The side guides should be set
exactly to the paper size to
avoid paper misfeeds.
❒ Do not load different kinds of
paper in the tray.
EEEE
Slide the paper tray completely
into the printer.
Important
❒ Be sure to insert the paper tray
completely. Otherwise, mis-
feeds might occur.
• When pulling the paper tray out,
be careful not to pull it strongly. If
you do, the tray might fall and
cause an injury.
ZHBY010E
ZHBY040E
ZHBY060E
ZHBY020E
AresPGBMaintGuide-F_FM.book Page 22 Friday, July 26, 2002 5:17 PM