Accessing the calibration mode – Raymarine autopilot User Manual
Page 91
78
ST6001+ Autopilot Control Unit - Owner’s Handbook
Accessing the Calibration mode
You can only access Calibration mode from Standby mode:
1. With the autopilot in Standby mode, press and hold the standby
key for 2 seconds. The display will change to show DISPLAY CAL.
2. Press the disp key to scroll down through the 4 calibration
groupings:
•
Display Calibration (DISPLAY CAL)
•
User Calibration (USER CAL)
•
Seatrial Calibration (SEATRIAL CAL)
•
Dealer Calibration (DEALER CAL)
Note: You can go backwards through the groups by pressing and
holding the disp key for one second.
3. When you reach the Calibration group you want to access, press
the auto key to enter that group:
To prevent accidental access, we have made entry to Dealer
Calibration more difficult than the other groups. After pressing
the auto key, the display will show CAL ?. When you see this,
press the -1 and +1 keys together to enter Dealer Calibration.
4. When you have entered one of the Calibration groupings, press
disp key to scroll down through the items within that grouping:
Note: You can go backwards through the list by pressing and holding
the disp key for one second.
5. When you reach an item you wish to adjust, use the -1, +1, -10 and
+10 keys (as appropriate) to change the value.
6. If you then want to adjust settings in another Calibration group,
press the standby key and then repeat steps 2 to 5 as necessary.
7. When you have made all the changes you want to make, press and
hold the standby key for two seconds to exit Calibration mode
and save changes.