Rheem Water Heater - Manual (Page 28)

INSTALLATION – SOLAR STORAGE TANK
28
SADDLING - PIPE WORK
To prevent damage to the cylinder when attaching pipe clips or saddles to the
water heater jacket, we recommend the use of self-drilling screws with a
maximum length of 13 mm. Should pre drilling be required, extreme caution
must be observed when penetrating the jacket of the water heater.
Note: Damage to the cylinder as a result of saddling to the jacket will void
the warranty.
BOOSTER HEATING UNIT
The booster heating unit provides hot water during periods of low solar gain.
This can be connected to either Extended Off-Peak (overnight and day)
electricity supply or a continuous / time of use electricity supply. Boosting can
be controlled via a user operated manual switch. Refer to
“Manual Controls” on
page 46.