Rheem Water Heater - Manual (Page 60)

COMMISSIONING
60
ircuit fluid on the side of the solar
r.
Sola
9. onnecting plug l
tab i cover opening.
It is
proc
com
the solar circuit is complete, to
othe trical
supply is
pum
hour
it
no solar gain
10. Swit
tank
8. Mark the static level of the closed c
storage tank with a non permanent marke
r Circuit Circulation
Disconnect the hot sensor lead from the c
n the upper front
ocated on the
important, at the end of this
edure when the
missioning and checking of
reconnect the hot sensor lead,
rwise when the elec
switched on, the solar
p will deactivate after one
and the solar control un
will then enter a fault mode and
will be achieved.
ch on the electrical supply at the isola
.
disconnect
hot sensor
lead
ting switch to the solar storage
W ea inside the solar sto k
behi power is on as the electrical circuit will
ping closed circuit fluid around
lear hose will slow
inutes (one and two cto
ill operate for one hour with th
tself off (refer to step 13 ) .
arning: Take care not to enter the ar
nd the front covers whilst the
rage tan
be live.
The red LED on the solar monitor label will
The pump will activate and commence pum
the solar circuit.
start flashing.
The level of the closed circuit fluid in the c
dynamic operating level.
Allow the pump to operate for three (3) m
systems) or for five (5) minutes (3 collecto
circuit to fill with closed circuit fluid and stabilise.
Note: The solar pump w
ly drop to the
colle r
r system) to allow the solar
e hot sensor lead
disconnected, before automatically turning i