Roberts Gorden CoRayVac CRV-B-6 - Manual (Page 15)

SECTION 5: M AJOR C OMPONENTS
9
SECTION 5: MAJOR COMPONENTS
The figures in this section provide a general overview
of component placement in a CRV-Series system.
The location of some components such as supports
and couplings is crucial for proper installation.
Assemble the heater components as shown on Page
15, Figure 13
.
Optional reflector configurations are shown on Page
5, Figure 3
through Page 7, Figure 11. Install
appropriate suspension hardware, beam clamps,
chain or rod at predetermined locations. Adjustments
of chain length will provide uniform pitch.
FIGURE 12: Major Component Descriptions
Burner Tube
Hot rolled, heat treated or
coated aluminized tube
supplied in 10' (3 m) lengths.
45° Elbow 90° Elbow
End Vent
Coupling Assembly
with Lock
Flex Gas Line
with shut-off cock
Combustion Chamber Tee
Reflector
(Aluminum or
Stainless Steel)
Alternate overlap as
shown on Page 22,
Section 7.4.3
. Minimum
overlap is 6" (16 cm).
Reflector with Hole
(Aluminum or
Stainless Steel)
Alternate overlap as
shown on Page 22,
Section 7.4.3
. Minimum
overlap is 6" (16 cm).
Tube Adapter
Cross