Rena DA615 - Manual (Page 35)

Printer functions
\text\etd\DA615\printerf 5.6 DA615 instruction manual
Fonts In selecting your fonts, refer to the section entitled “Fonts”. Thirteen
different fonts are installed in the printer. If more fonts are present,
only the first 25 are shown. The following sequence is observed:
works fonts
soft fonts.
Print Quality You may select between six print qualities:
The numbers specify the number of print dots per character.
The higher the number, the better the print quality.
600D 450D 300D 300F 200D 150D :
High print quality Low print quality
Slow print Fast print
Left Margin This menu allows you to set the spacing between the printing area and
the first printed character in the range between 0-304 mm.
When the PREV/NEXT key is pressed continuously, the change is
performed in cm-steps, otherwise in mm-steps.
Top Margin This menu allows you to set the spacing between the paper edge and
the first printed line in the range between 0-50 mm.
When the PREV/NEXT key is pressed continuously, the change is
performed in cm-steps, otherwise in mm-steps.
Type of
barcode Use this menu to select a barcode.
The following barcodes are available:
ZIP barcode
bpo4 barcode
kix barcode
cana barcode
2/5 interleaved barcode coda barcode
co39 barcode
c128 barcode
ean barcode
If you acknowledge the "ZIP" barcode with the ENTER key, you will be
offered the following parameter setting:
" BARCODE OPTIONS: off "
BARCODE
OPTIONS
(Only for USA !) You may select between the options "off", "zip" and "dpbc".
In the setting "ZIP" the nine (or five) digits of the postal code from the
"ZIP line" are recognized and the corresponding barcode (with check
sum) is printed. The line with the "D
LE
" sequence (see interface
description - Sect. 8 Zip barcode) in the addressing is then obviated.