Rena DA615 - Manual (Page 36)

Printer functions
\text\etd\DA615\printerf 5.7 DA615 instruction manual
The numbers of the postal code should be sent in the last line of the
address. The postal code cannot have more than nine digits, but must
have at least five. As the number sequence search starts from the end
of the address, the last nine digits of a sequence are converted. You
may add a separating hyphen or other printable character between the
fifth and sixth digits.
At the "DPBC" setting, the program searches for the house number at
the start of the street line and adds it to the ZIP barcode.
The street line must be sent to the printer before the line containing the
postal code. The house number should be at the beginning of the line.
Where the house number consists of three digits, only the last two are
converted into barcode. House numbers consisting of only a single digit
are preceded by a 0.
BARCODE
POSITION After you acknowledge your choice in the "BARCODE OPTIONS"
menu field, the following display appears:
"BARCODE POSITION : top"
The ZIP barcode position can be defined by the options "top" or "bot".
These define the position of the ZIP barcode within the address block.
The following variants are possible:
top: the barcode line is printed as the first address line.
bottom: the barcode line is printed after the last address line.
Other barcodes If you acknowledge barcode "2/5i", "coda", "co39" or “c128” with the
ENTER key, you will be offered the following parameter setting:
"SMALL WIDTH : 6"
SMALL WIDTH You can set the width of the narrow bar from 1 to 99 (dots).
LARGE WIDTH After you have acknowledged your setting in the "SMALL WIDTH"
menu field, the following appears:
"LARGE WIDTH : 15"
You can now set the width of the thick bar from 1 to 99 (dots).
BARCODE
HEIGHT After you have acknowledged your setting in the "LARGE WIDTH"
menu field, the following appears:
"BARCODE HEIGHT : 50"
You can now set the height of the barcode from 1 to 999 (dots).
☞ A maximum of 50 dots can be printed with a single traverse
of the print-head.
Other barcodes If you acknowledge the barcode "ean" with the ENTER key, then you
will be offered only the parameter setting "BARCODE HEIGHT" - as
already described.