Rena DA615 - Manual (Page 58)

Error messages and hints
\text\etd\DA615\Error 8.2 DA615 instruction manual
Error message Cause Solution
TEST MACRO TOO LONG The user-defined test
address is too long. Limit the size of the test
address to 3 Kbytes.
BUFFER OVERFLOW !! Error in data transfer. Check connections of the
interface cable.
EPROM ERROR !!
VERIFY FONT
Error in the Flash prom. Reload the RENA fonts.
EPROM ERROR !!
VERIFY PROG
Reload the program
(firmware).
RAM ERROR !!
VERIFY RAM
Error in RAM. Arrange for the CPU board
to be replaced by service
personnel.
PROGRAM ERROR !!
MAKE DEFAULT RESET
Error in program
execution. - Perform a default ini-
tialization (Sect. 5)
- Reload the firmware.
UNPRINTED ADDRESSES !
FINISH THE JOB
Address was not printed to
the end. Make no changes in
programming mode when
the print job is running!
PIC ERROR
VERIFY CONTROLLER
Error in controller module
that controls the paper
transport. - Check module PIC 1665.
- Set the paper feed
mechanism properly.
PIC TIME OUT
VERIFY CONTROLLER
PIC STATUS ANSW.
PAPER OUT (PAP)
PIC CALL
PROGRAM ERROR
TIME OUT PIC
WAITING FOR PAPER
PIC CODE
PAPER OUT (PAP)
IBF ERROR
VERIFY CONTROLLER
PIC OBF ERROR
PAPER OUT (PAP)