Runco PL-61DHD - Manual (Page 29)

Installation
Runco PlasmaWall Owner’s Operating Manual 19
PRE
L
IMINAR
Y
Ventilation If you are mounting the PlasmaWall in an enclosure, leave at least 2 inches (50 mm) of
space on all sides between it and surrounding objects, as shown in Figure 3-2. This allows
heat to disperse, maintaining the proper operating temperature.
Figure 3-2. Ventilation Requirements for Enclosure Mounting
Other Considerations Other considerations and tips that can help improve your installation, avoid damage and
prolong operating life:
• Keep the ambient temperature constant and below 35°C (95°F). Keep the display away
from heating and/or air conditioning vents. Changes in temperature may cause drifts in
the display circuitry, which may affect performance.
• Keep the PlasmaWall away from devices that radiate electromagnetic energy such as
motors and transformers. Common sources of these include slide projectors,
speakers, power amplifiers and elevators.
• Handle the unit carefully when installing or carrying it. Use the built-in handles; DO NOT
touch or hold the screen face.
• Set the unit away from heat, excessive dust, and direct sunlight.
• Protect the inside of the unit from liquids and small metal objects. In case of accident,
unplug the power cord and have it serviced by an authorized Service Center.
• Do not hit or scratch the panel surface as this causes flaws on the surface of the
screen.
• For correct installation and mounting it is strongly recommended to use a trained,
authorized dealer.
• To avoid sulfurization, it is strongly recommended not to place the unit in a dressing
room in a public bath or hot spring bath.
50 mm (2")
50
mm
(2")
50
mm
(2")
Wall
Wall
50 mm (2")
50 mm (2")