4 connections to the plasmawall and dhd controller, Connecting the plasmawall to the dhd controller, Connections to the plasmawall and dhd controller – Runco PL-61DHD User Manual
Page 30: 3. connecting the plasmawall to the dhd controller, Pre l iminar y
20
Runco PlasmaWall Owner’s Operating Manual
PRE
L
IMINAR
Y
3.4
Connections to the
PlasmaWall and DHD
Controller
Proceed as follows to connect the PlasmaWall to the DHD Controller, your video sources,
external controller(s) -- if present -- and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
• Use the left audio input when connecting mono audio sources.
Connecting the
PlasmaWall to the DHD
Controller
Connect the DHD Controller to the PlasmaWall as shown in Figure 3-3 and described in
the sections that follow.
Figure 3-3. Connecting the PlasmaWall to the DHD Controller
➤
PC/
RGB
DVD/HD3
EXTERNAL
CONTROL
(RS-232)
DHD Controller
RS-232
OUT
DVI
OUT
RGB-HV
OUT
Pb
Pr
Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
HD1
HD2
1
2
R/Pr
G/Y
B/Pb
R/Pr
G/Y
B/Pb
H
V
DVI 1
DVI 2
DVI Out
H/V
V
H
R/Pr
G/Y
B/Pb
H
V
TRIGGERS
RS-232 Out
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
100-230VAC 50-60 Hz, 165 Watts Max
OUTPUTS
INPUTS
SYSTEM CONTROL INTERFACE
Component Video
SDI
Option
Serial No
Video Processor / Controller
Model
Runco International
Union City, CA
Made In USA