Radio Shack 7-in-1 Remote Control with Lighted Keypad - Manual (Page 13)

Need help? Call 1-800-989-4706
13
Entering a Plug ’n Power House Code
Your IR Command Console or Plug ’n Power
Wireless Remote Control System uses a master
code called a house code (see your IR Command
Console’s or Plug ‘n Power Wireless Remote
Control System’s Owner’s Manual for more infor-
mation).
1. Press Plug ’n Power on the 7-in-1 Remote
Control.
2. Hold down SET UP on the 7-in-1 until the red
light above turns on.
3. Use the 7-in-1’s number keys to enter the
numbers equivalent to the house code’s let-
ters (
1 for A, 2 for B, 3 for C, and so on).
For example, if the house code is C, press 3 .
4. Press ENT on the 7-in-1.
When the red light turns off, the 7-in-1 has
accepted the code.
Note: If the code you entered is invalid, the
red light flashes for about 3 seconds then
turns off. Start again from Step 1.
Controlling Lights and Appliances Using
an IR Command Console
Follow these steps to control Plug ’n Power mod-
ules with your 7-in-1 using an IR command con-
sole.
1. Position the IR command console within the
7-in-1’s line of sight.
2. Plug the IR command console’s power cord
into any standard AC outlet.
3. Set the house code dial on top of the IR com-
mand console to the same letter as your
Plug ’n Power modules.
4. Set the selector switch on the IR command
console for the group of modules you want to
control (1–4 or 5–8).
15-1924.fm Page 13 Monday, July 19, 1999 12:50 PM