Radio Shack 7-in-1 Remote Control with Lighted Keypad - Manual (Page 9)

Need help? Call 1-800-989-4706
9
SETTING UP YOUR 7-IN-1
1. Refer to “Manufacturers’ Codes” on Page 23
and write down the codes for your original
remote controls.
Notes:
• Some manufacturers have several possi-
ble codes listed. Try each until you find the
right one. See “If You Have Problems” on
Page 20 if you cannot find the correct
code.
• If you want to set up your 7-in-1 to control
a combination TV/VCR (such as Cat. No.
16-421 or 16-422), you must program the
TV code for the TV functions and the VCR
code for the VCR functions.
2. Hold down SET UP until the red light above
turns on.
Note: To exit the set up routine at any time,
press
SET UP again. The red light flashes
several times.
3. Press the device key for the type of remote
you are replacing ( TV , VCR , CBL , CD , Plug ’n
Power, or SAT ).
Note: If you do not press a device key within
about 15 seconds, the red light flashes for
about 3 seconds then turns off. Start again
from Step 2.
4. Enter the 3-digit code.
For example, to replace a TV’s remote con-
trol (manufacturer’s code 185), press:
SET UP – TV – 1– 8 – 5
When the red light turns off, the 7-in-1 has
accepted the code.
Note: If the code you entered is invalid, the
red light flashes for about 3 seconds then
turns off.
15-1924.fm Page 9 Monday, July 19, 1999 12:50 PM