Radio Shack 7-in-1 Remote Control with Lighted Keypad - Manual (Page 16)

Need help? Call 1-800-989-4706
16
9. To brighten or dim lights connected to lamp
and appliance modules, press the digit key
for the module you want to control. Then
hold down
VOLUME + (Brt) or VOLUME –
(Dim) on the 7-in-1. Release the key when
the desired level of brightness is reached.
Note: You must select the individual light to
brighten or dim even if you used
POWER (All
Lts On) on the 7-in-1 to turn on all the lights
at the same time.
Setting a Plug ’n Power Timer
You can set the 7-in-1 Remote Control to turn on
or off a lamp/appliance module you select or turn
off all modules after a period of 1 to 99 minutes.
This works with an optional IR command console
or Plug ’n Power Wireless Remote Control Sys-
tem.
Note: When you use the 7-in-1 to control all mod-
ules at one time, the only command that works is
All Off .
1. Press Plug ’n Power on the 7-in-1.
2. Hold down TIMER on the 7-in-1 until the red
light above stays on.
Note: Skip Step 3 if you are turning all mod-
ules off using the
All Off command.
3. To turn on or off a specific module using the
7-in-1 Remote Control, press the digit keys
to enter the module’s device code. The red
light blinks once.
4. Press On ( CHANNEL + (On) (to set a module
to turn on), Off ( CHANNEL – (Off) (to set a
module to turn off), or MUTE (All Off) (to set
all modules to turn off.
When the red light blinks once, the 7-in-1
has accepted the code.
15-1924.fm Page 16 Monday, July 19, 1999 12:50 PM