Radio Shack 7-in-1 Remote Control with Lighted Keypad User Manual
Page 21
Need help? Call
1-800-989-4706
21
• Because the 7-in-1’s library has so many
codes, this procedure can take several
minutes.
• If your device turns off during the search,
but does not operate after you lock in the
code, begin the search again, pausing
longer between key presses.
If necessary, repeat these steps for each device.
Determining the 3-Digit Code
After you set up your 7-in-1 Remote Control using
manual code search, you can find which 3-digit
code the 7-in-1 Remote Control is set to by follow-
ing these steps.
1. Hold down
SET UP
until the red light above
turns on.
2. Press the device key you want to get the
manufacturer’s code from. The red light
blinks once then stays on.
3. Press
SET UP
. The red light blinks once then
stays on.
4. Press
0
–
1
–
2
–
3
–
4
–
5
–
6
–
7
–
8
–
9
, wait-
ing a few seconds after you press each num-
ber before you press the next one.
If the red light blinks after you press a num-
ber, that number is the first number of your 3-
digit manufacturer’s code.
5. Repeat Step 4 twice to find the second and
third numbers of your 3-digit manufacturer’s
code. After the red light blinks for the third
digit in the code, it turns off.
15-1924.fm Page 21 Monday, July 19, 1999 12:50 PM