Radio Shack 7-in-1 Remote Control with Lighted Keypad - Manual (Page 17)

Need help? Call 1-800-989-4706
17
Note: If the code you entered is invalid, the
red light flashes for about 3 seconds.
5. Use the 7-in-1’s number keys to enter the
time you want to set. For example, if you
want to enter 15 minutes, press
1–5 .
When the red light blinks once, the 7-in-1
has accepted the code.
Note: If the time you entered is invalid, the
red light flashes for about 3 seconds. Start
again from Step 1.
6. Press ENT on the 7-in-1. The red light turns
off.
To cancel the timer, press Plug ’n Power on the
7-in-1, then hold down
TIMER until the red light
blinks.
TEACHING COMMANDS TO THE
7-IN-1
You can teach infrared commands from one or
more original remote controls to your 7-in-1 Re-
mote Control, storing each command in one of
the 7-in-1’s keys. This is handy if a prepro-
grammed manufacturers’ code you selected does
not control all of your device’s functions, or if none
of the manufacturers’ codes work for your device.
You can teach the functions of as many as 3 orig-
inal remote controls, with as many as 50 keys
each, to the 7-in-1.
Notes:
• Depending on how commands are stored in
your original remote control, you might not
be able to store all of the remote control’s
commands into your 7-in-1.
15-1924.fm Page 17 Monday, July 19, 1999 12:50 PM