Radio Shack 7-in-1 Remote Control with Lighted Keypad - Manual (Page 15)

Need help? Call 1-800-989-4706
15
Controlling Lights and Appliances Using
a Control Center Module
Follow these steps to control Plug ’n Power mod-
ules with your 7-in-1 using your Plug ’n Power
Wireless Remote Control System’s control center
module.
1. Plug the control center module’s power cord
into any standard AC outlet.
2. Set the house code dial on top of the control
center module to the same letter as your
Plug ’n Power modules.
3. Set the unit selector switch on the control
center module for the group of modules you
want to control (1–8 or 9–16).
Note: If the 7-in-1’s Plug ’n Power code is
already set to
0 – 1 – 3 (the default), skip
Steps 4 and 5.
4. Hold down SET UP on the 7-in-1 until the red
light above turns on.
5. Press Plug ’n Power then enter 0 – 1 – 3 on
the 7-in-1. The red light turns off.
6. On the 7-in-1, enter the house code that
matches your control center module’s house
code (see Step 3 under “Entering a Plug ’n
Power House Code” on Page 13).
7. To turn on all light and appliance modules set
to the same house code as the control center
module, press
POWER (All Lts On) on the 7-
in-1.
To turn off all light and appliance modules set
to the same house code as the control center
module, press
MUTE (All Off) on the 7-in-1.
8. To turn specific lights and appliances on or
off, press the digit key ( 1 – 16 ) for the module
you want to control. Then press On or Off
( CHANNEL + (On) or CHANNEL – (Off) ).
15-1924.fm Page 15 Monday, July 19, 1999 12:50 PM