Radio Shack 7-in-1 Remote Control with Lighted Keypad - Manual (Page 19)

Need help? Call 1-800-989-4706
19
from a VCR’s original remote control, press
PLAY on the 7-in-1.
If the key you want to program is already
used for another command, press
SHIFT
before pressing the key. For example, to
store the command SHIFT-PLAY, press
SHIFT then PLAY on the 7-in-1.
7. On the original remote control, hold down the
key that you want your 7-in-1 to learn until
the red light on the 7-in-1 blinks once.
Note: If the command was not programmed
properly, the red light blinks for about 3 sec-
onds then turns off. If this happens, repeat
Steps 4–7.
8. Repeat Steps 1–7 to store more commands.
9. When you finish, press ENT on the 7-in-1 to
save all stored commands.
Note: If you do not press a key within 15 seconds,
the red light blinks for about 3 seconds then turns
off. Begin again from Step 1.
Clearing All Commands
1. Hold down SET UP on the 7-in-1 until the red
light above turns on.
2. Press the device key on the 7-in-1 for which
you want to clear all commands. The red
light blinks once.
3. Press LEARN on the 7-in-1 twice. The red
light flashes for a few seconds.
4. Press SET UP on the 7-in-1. After a few sec-
onds, the red light flashes then turns off.
15-1924.fm Page 19 Monday, July 19, 1999 12:50 PM