Section 10 normal and fault condition led messages, Power on led, Diagnostic led – RoboteQ Dual Channel Digital Motor Controller AX2550 User Manual
Page 99: Normal operation flashing pattern, Section 10, Normal and fault condition led messages
AX1500 Motor Controller User’s Manual
99
Power On LED
SECTION 10
Normal and
Fault Condition
LED Messages
This section discusses the meaning of the various messages and codes that may be dis-
played on the LED display during normal operation and fault conditions.
Power On LED
The AX1500 features an LED that comes on whenever the board is powered on. When lit,
this LED indicates that the on-board DC/DC converter is functioning. It provides no infor-
mation regarding the controller’s operation.
Diagnostic LED
The AX1500 features a single diagnostic LED which helps determine the controller’s oper-
ating mode and signal a few fault conditions. The LED is located near the edge of the
board, next to he 15-pin connector.
Normal Operation Flashing Pattern
Upon normal operation, 1 second after power up, the LED will continuously flash one of
the patterns below to indicate the operating mode. A flashing LED is also an indication that
the controller’s processor is running normally.