Raritan Computer SX - Manual (Page 103)

C HAPTER 10: M AINTENANCE 85
Performing a Factory Reset on the DSX
Performing a factory Reset returns the DSX unit to its default factory settings. Be very careful
when doing this, because it will erase all the data and settings on the DSX unit and return it to the
state in which it was originally shipped.
To perform a factory reset, click the Maintenance tab, and then click Factory Reset. You will be
prompted to confirm the reset. Click Yes to proceed. If you change your mind, click No.
Note: In case you are not aware of the administrative password to log in the DSX GUI to
perform a factory reset, you may want to try resetting from the DSX hardware. To do so,
insert a pin into the RESET hole on the back panel of DSX unit and hold for about 15 seconds.
Then the DSX is reset back to factory defaults.
Rebooting the DSX
Performing a reboot powers the DSX off and then back on. Be careful when doing this, because it
will log all current users off the system.
To perform a reboot, click the Maintenance tab, and then click Reboot. You will be prompted to
confirm the reboot. Click Yes to proceed. If you change your mind, click No.