Raritan Computer SX - Manual (Page 52)

34 D OMINION SX U SER G UIDE
6. Select the escape mode. The default is None. Change as follows:
• Select Control from the drop-down menu in the Escape Mode field.
• Type the Escape Character. The default for the Dominion SX is ] (closed bracket ).
7. Select the terminal emulation type from the drop-down menu in the Emulation field. The
choices are:
• VT100
• VT220
• VT320
• ANSI
8. If you plan to use Direct Port Access (DPA), you must enter the DPA IP Address, as well as
one or both of the following:
• The port number, such as 7700, in the DPA SSH TCP Port field
• The port number, such as 8800, in the DPA Telnet TCP Port field .
9. Click OK.
Direct Port Access
To configure direct port access:
1. Click the Setup tab, and then click Services. The Network Service Settings screen appears.
The Direct Port Access Mode field is at the bottom of the screen.
Figure 28 Direct Port Access Mode Field
2. Go to the Direct Port Access Mode field. The default is Normal, which means disabled. To
enable DPA, select either IP or TCP Port from the drop-down menu.
3. Click OK to save this information. The screen displays the following message:
The system will need to be rebooted for changes to take effect.
4. Reboot now or reboot after completely configuring for DPA.
5. Click the Setup tab, and then click Port Configuration. The Port Configuration screen
appears. (Figure 26).
6. Select the ports to configure for direct port access:
• To select specific ports, click the checkboxes to the left of the port number. You can
select more than one. When you have finished, lick Edit.
• To select all the ports, click Select All.
The Edit Port Configuration screen appears (Figure 27). The DPA fields are at the bottom of
the screen.
7. Type the DPA IP address of the DSX, and the DPA ports used for SSH and Telnet in the
appropriate fields.
8. Click OK to save this information.
9. Reboot the DSX unit. This is necessary for the direct port access settings to take effect.
.