Ricoh AP3800C User Manual
Page 31
Replacing the Fusing Unit
21
1
MMMM
Holding the green handle of the
new Fusing Unit, use your other
hand to push the area right in
front of the handle to create a
slight slant, and then push the
Fusing Unit slowly to the back.
Important
❒ Confirm that the Fuser Oil Unit
is facing the inside of the print-
er.
❒ Confirm that the Fusing Unit is
properly positioned in the ma-
chine.
NNNN
Close the upper left cover (
A
A
A
A) and
push the handle (
B
B
B
B) slowly to the
back until it clicks into place.
OOOO
If you removed the External Tray
in step
DDDD
, reattach it to the printer.
Insert the hooks of the External
Tray into the printer slits, and
lower it toward you.
PPPP
If the Duplex Unit is installed,
close the Duplex Reversal Unit.
Reference
See p.2 “Opening and Closing
the Duplex Reversal Unit”
QQQQ
If the 2 Tray Finisher was in-
stalled, reattach the 2 Tray Finish-
er to the printer.
Reference
See p.1 “Detaching the SR770 (2
Tray Finisher)”
RRRR
Plug in the power cable and turn
on the power switch.
The following message appears on
the panel display. Please wait for a
while.
ZDJH050E
ZDJH051J
Please Wait
ZDJH010J
JupP1k_GB_Mainte_F_FM.book Page 21 Thursday, August 22, 2002 4:23 PM