Ricoh AP3800C - Manual (Page 74)

Paper and Other Media
64
3
Load Paper in the Bypass Tray
Besides regular paper, you can load
thick paper, envelopes, OHP trans-
parencies, and paper that is longer
than A3
L onto the Bypass Tray,
which cannot be loaded in the Paper
Trays or Paper Feed Unit.
Note
❒ Paper sizes supported by the By-
pass Tray are 90 - 305 mm in width,
and 148 - 458 mm in length.
❒ If you load custom size paper or
special paper, select the paper size
with the control panel. The RPCS
printer driver can select the paper
size with the printer driver proper-
ties. The paper size selected with
the printer driver overrides the
one selected with the control pan-
el. See p.66 “Specifying a custom
paper size for the Bypass Tray”.
❒ If you load thick paper, OHP trans-
parencies, or envelopes, make the
settings for thick paper or OHP
transparencies with the control
panel or printer driver. See p.67
“Specifying a paper type for the
Bypass Tray”.
❒ The number of pages that can be
loaded in the Bypass Tray differs
depending on the paper type. Con-
firm that the top of the stack is not
higher than the limit mark inside
the tray.
Limitation
❒ You cannot use the following func-
tions when printing on paper that
is loaded in the Bypass Tray.
• Duplex Print
• Collate, Job Separation
• Staple/Punch
• Auto Tray Select
AAAA
Open the bypass tray.
Note
❒ If you load A4 or larger size pa-
per, pull out the bypass tray ex-
tension, and then flip it open.
ZDJH202J
ZDJH203J
JupP1k_GB_Mainte_F_FM.book Page 64 Thursday, August 22, 2002 4:23 PM