Oki B 6300 - Manual (Page 58)

54 10 Troubleshooting
When Using UNIX
The Printer Is Not Printing
Unable to Obtain Desired Print Results
Causes Verification Action
Incorrect IP address. Ask the network administrator to check if the
IP address is correct. Set up the correct IP address for the printer.
Error occurs on the
network connecting the
workstation and the
printer. Activate the network test mode (ping) on the
workstation to check the communication
status. Ask the network administrator to look into the
network failure.
Unable to set the correct
printer entry on the
workstation. Check and correct the printer entry settings
on the workstation. Check the /etc/printcap
file on the workstation or use the “lpstat”
command to troubleshoot. Re-enter the correct printer entry.
The printer is in the offline
status. Check whether “Off-line” is displayed on the
printer control panel. Press the <ON LINE> button.
If LPD spool is set to
[Memory], the print data
sent by the user in a single
print instruction has
exceeded the upper limit
of the receiving capacity
set up by the printer
control panel of the printer. Check the upper limit of the receiving
capacity from the printer control panel and
compare it with the print data which was sent
in the single print instruction. 1. If a single file of print data has exceeded
the upper limit of the receiving capacity,
split the file into smaller ones to keep
them below the upper limit of the
receiving capacity.
2. If multiple files have exceeded the upper
limit of the receiving capacity, reduce the
number of files which can be sent at one
go.
An irrecoverable error has
occurred during printing. Check the error message on the printer
control panel. Switch off the printer, then switch it on again.
The data format of the
print job does not conform
to the printing
environment of the
workstation. (Print data
from the client contains
TBCP.) - Specify PSASC on the client side to print data
containing TBCP by the PostScript language.
The data format of the
print job does not conform
to the printing
environment of the
workstation. (Print data
from the client is of a
binary format.) - Specify PSBIN on the client side for the
printer name on the remote host to print a
binary file in the PostScript language.
The printer has run out of
paper. Check the message on the printer control
panel. Load paper into the paper tray.
Causes Verification Action
The indicated print
language and the print
language used in the print
data are different. Check that the print language specified is the
print language used in the print data. Specify the print language consistent with
that used in the print data.