Omega Vehicle Security freedom OM-550 - Manual (Page 45)

OM-550 u 40 u
5.0 OPERATION
The following section will guide the user through a typical logging process. These steps
may vary depending on the type of data the user is logging. When using this procedure
it may be necessary to refer to section 4.0 PROGRAMMING for proper programming
procedures and alternate options.
1. Turn the OM-550 “ON”.
2. Press the PROG key to confirm the current programming information.
Figure 5-1: Programmed Information
If the channel information is correctly programmed press the EXIT key to accept
the current settings and the OM-550 is ready to log data.
2. Select a type of voltage or thermocouple input for each channel (J, K, T, E, V,
SKIP), or press OK to advance to the next item.
Figure 5-2: Channel Type Selection