Oricom M5200 Series - Manual (Page 27)

25
CORDLESS HANDSET OPERATION
Cordless handset keypad lock
During standby mode,
1
. Press and hold key to lock the keypad.
2
. To release keypad lock, press and hold
key for 3 seconds.
Note : When the keypad is locked, key and INT key can be used to answer
an external or intercom call.
Registration
HANDSET
1
Register new handsets on the M5200 base
The handsets which come in the same pack are already registered to the base. If you
buy new handsets. You need to register them before use.
1 . Charge the batteries (for 15 hours).
2 . Register the handset (to the base unit).
Each handset can register to four base at a time. Each base can register up to 4
handsets.
During standby mode,
1
. Press key.
2
. Press or key to select
“REGISTER” from the display.
3
. Press key. The display on the right is shown.
4
. Press 1 on the handset to verify base station.
5
. Press key to confirm.
6
. Press and hold key. The base is now in the registration mode.
7
. Press the numeric keys to enter the default PIN (0000).
REGISTER
BS ?