Oricom M5200 Series - Manual (Page 31)

29
ANSWERING MACHINE OPERATION
Answering machine Ring delay Setting
This setting is used to set the ring times.
Default number of ring -3
1
. Press and hold 2-9/GS key (bottom of base) for 2 seconds.
“Set rings” will be heard followed by a short beep, after a pause then prompt
current rings.
2
. Press ANS or MEMO key to select item. Voice prompt at each selection will be
heard. There are 2-9 and TS mode (Toll saver) for you to select.
3
. Press 2-9/GS key to confirm setting and go back to standby or off mode.
Answering machine PIN number Setting
Default code - 000
1
. Press and hold CODE key (bottom of base) for 2 seconds. “Set security code”
can be heard followed by a short beep, after a pause then prompt the first code.
2
. Press ANS or MEMO key to select the first digit. Voice prompt at each selection
will be heard.
3
. Press CODE key located on the bottom of the base (see page 10) to confirm
setting and go to next setting. The voice prompt will be heard.
4
. Press ANS or MEMO key to select the second digit. Voice prompt at each
selection will be heard.
5
. Press CODE key to confirm setting and go to next setting. The voice prompt will
be heard.
6
. Press ANS or MEMO key to select the third digit. Voice prompt at each
selection will be heard.
7
. Press CODE key to confirm setting and go back to standby or off mode.
Note:
Press key any time or 5 seconds without any operation will quit setting
mode and will go back to standby or off mode. All settings are unchanged.