Onkyo TX-SA706 - Manual (Page 24)

24
Connecting the AV Receiver/AV Amplifier
—Continued
■ Signal Selection
If signals are present at more than one input, the
inputs will be selected automatically in the fol-
lowing order of priority: HDMI, component
video, S-Video, composite video.
In the Signal Selection Example shown on the
right, video signals are present at both the S-
Video and composite video inputs, however, the
S-Video signal is automatically selected as the
source and video is output by the S-Video and
HDMI outputs.
Audio Connection Formats
Audio equipment can be connected to the AV
receiver/AV amplifier by using any of the follow-
ing audio connection formats: analog, optical,
coaxial, analog multichannel, or HDMI.
When choosing a connection format, bear in
mind that the AV receiver/AV amplifier does not
convert digital input signals for analog line out-
puts and vice versa. For example, audio signals
connected to an optical or coaxial digital input
are not output by the analog TAPE OUT.
If signals are present at more than one input, the inputs will be selected automatically in the following order of priority:
HDMI, digital, analog (including multichannel). You can specify which audio inputs the AV receiver/AV amplifier
checks for the presence of a signal in the “Automatic Audio Input Selection Setup” on page 96.
The onscreen setup menus appear only on a TV that is connected to the HDMI OUT. If your TV is connected to the
composite video or S-Video MONITOR OUT, or the COMPONENT VIDEO MONITOR OUT, use the AV
receiver/AV amplifier’s display when changing settings.
IN
MONITOR OUT
DVD player, etc.
AV receiver/
AV amplifier
TV, projector, etc.
Composite
Composite
S-Video
S-Video
Component
Component
Signal Selection Example
HDMI
HDMI
IN
OUT
DVD player, etc.
AV receiver/
AV amplifier
MD recorder, etc.
HDMI Coaxial Analog
Audio Signal Flow Chart
Multichannel
HDMI Analog
Optical
*1 Depends on the “Audio TV Out” setting
(see page 93).
*2 Only the front L/R channels are output
(There will be no down mix.).