Onkyo TX-SA706 - Manual (Page 47)

47
First Time Setup
—Continued
For AM tuning to work properly, you must specify the
AM frequency step used in your area. Note that when
this setting is changed, all radio presets are deleted.
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
AM Frequency Step Setup
(on some models)
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ] but-
tons to select “7. Hardware
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.
3 Use the Up and Down [ ]/[ ] but-
tons to select “3. Tuner”, and
then press [ENTER].
The “Tuner” menu appears.
4 Use the Left and Right [ ]/[ ]
buttons to select:
10kHz: Select if 10 kHz steps are
used in your area.
9kHz: Select if 9 kHz steps are used
in your area.
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog
Multich
5. HDMI
7–3. Tuner
AM Frequency Step 9kHz
5 Press the [SETUP] button.
The setup menu closes.