Onkyo TX-SA706 - Manual (Page 52)

52
First Time Setup
—Continued
Error Messages
While the automatic speaker setup is in progress, one of
the following error messages may appear:
❏ Ambient noise is too high.
This message appears if the background noise is too
loud and the measurements cannot be performed
properly.
Remove the source of the noise and try again.
Retry: Return to the measured point immediately
before and start set up again.
Cancel: Cancel the automatic speaker setup.
❏ Speaker Detect Error
This message appears if a speaker is not detected. “Yes”
means that a speaker was detected. “No” means that no
speaker was detected.
One of the front speakers has not been detected.
One of the surround speakers has not been detected.
The surround back speakers have been detected but
the surround speakers haven’t.
The right surround back speaker has been detected
but the left surround back speaker hasn’t.
The speaker type detected does not match what was
expected. The speaker may be or incorrect type or
broken. Please check that it is the correct speaker
type, or that all drivers are working.
The number of speakers detected on the second or
third measurement was different to the number
detected on the first measurement.
Make sure speakers that cannot be detected are con-
nected property.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker setup.
❏ Writing Error!
This message appears if saving fails.
Try saving again. If this message appears after 2 or 3
attempts, the AV receiver/AV amplifier is probably mal-
functioning. Contact your Onkyo dealer.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker setup.
Retry
Cancel
Ambient noise is too high.
Auto Speaker Setup
Auto Speaker Setup
Retry
Cancel
Speaker Detect Error
FL : Yes
SL : ---
SBL : ---
C : Yes FR : No
SR : ---
SBR :
---
SW : ---
Auto Speaker Setup
Retry
Cancel
Speaker Detect Error
FL : Yes
SL : ---
SBL : ---
C : Yes FR : Yes
SR : No
SBR :
---
SW : ---
Retry
Cancel
Auto Speaker Setup
Speaker Detect Error
FL : Yes
SL : ---
SBL : ---
C : Yes FR : Yes
SR : No
SBR : Yes
SW : ---
Retry
Cancel
Auto Speaker Setup
Speaker Detect Error
FL : Yes
SL : ---
SBL : No
C : Yes FR : Yes
SR : Yes
SBR : Yes
SW : ---
Retry
Cancel
Auto Speaker Setup
Speaker Detect Error
FL : Error
SL : Yes
SBL : Yes
C : Yes FR : Yes
SR : Yes
SBR : Yes
SW : Yes
Retry
Cancel
Speaker Detect Error
Auto Speaker Setup
Retry
Cancel
Writing Error!
Auto Speaker Setup