Onkyo TX-SA706 - Manual (Page 94)

94
Advanced Setup
—Continued
■ Control
This function allows
-compatible components
connected via HDMI to be controlled with the AV
receiver/AV amplifier.
Notes:
•
, which stands for Remote Interactive over
HDMI, is the name of the system control function
found on Onkyo components. The AV receiver/AV
amplifier can be used with CEC (Consumer Electron-
ics Control), which allows system control over HDMI
and is part of the HDMI standard. CEC provides
interoperability between various components, how-
ever, operation with components other than
-
compatible components cannot be guaranteed.
• Set to “Disable” when a connected piece of equipment
is not compatible or it is unclear whether the equip-
ment is compatible or not.
• If movement is unnatural when set to “Enable” , change
the setting to “Disable” .
• Refer to the connected component’s instruction man-
ual for details.
Power Control
To link the power functions of
-compatible
components connected via HDMI, select “Enable”.
Notes:
• The
“Power Control” setting can be set only when the
above “Control” setting is set to “Enable”.
• HDMI power control only works with -com-
patible components that support it and may not work
properly with some components due to their settings
or compatibility.
• When set to “Enable”, power consumption will
increase.
• When set to “Enable”, regardless of whether the AV
receiver/AV amplifier is On or on Standby, both audio
and video received by an HDMI input will be output
by the HDMI OUT for playback on the TV or other
component that’s connected to the HDMI OUT.
• Refer to the connected component’s instruction man-
ual for details.
TV Control
Set to “Enable” when you want to control the AV
receiver/AV amplifier from an
-compatible TV
that is connected to HDMI.
Notes:
• Set to
“Disable” when the TV is not compatible or
when it is unclear whether the TV is compatible or
not.
• The “TV Control” setting can be set only when the
above “Control” and “Power Control” settings are both
set to “Enable”.
• Refer to the connected component’s instruction man-
ual for details.
Disable: disabled (default).
Enable: enabled.
Disable: Power Control disabled.
Enable: Power Control enabled.
Disable: TV Control disabled.
Enable: TV Control enabled.
Note:
After changing the settings of the
“Control” , “Power
Control” , or “TV Control” , turn off the power to all
connected pieces of equipment and then turn on
again. Refer to the User’s Manuals for all connected
pieces of equipment.