Sylvania SREC427 - Manual (Page 59)

59
1
Press POWER button.
2 Press TIMER PROG. button. Timer Programming
list will appear.
3
Check the information.
4 To clear the timer programming, select your
desired program using K/L buttons, then press
CLEAR button.
To correct the timer programming, select your
desired program using K/L buttons, then press
ENTER button.
Next, correct the timer programming using
K
/L/s/B buttons.
Finally, press ENTER button again.
5 Press TIMER PROG. button to exit.
6
Press POWER button to return to the timer
standby mode.
NOTE:
• Press TIMER PROG. button to check the timer programming
in process.
When the timer recording is in process, that program will be
highlighted in red. In this case, you cannot select any other
program.
- - -
JAN/01
Setup > Recording > Timer Programming
1H
Date Start End CH
10:30PM 10:00PM CH8 DVD
DVD VCR
JAN / 1/ 2004 (THU) 12 : 00 PM
Speed
Checking, canceling, or correcting the timer pro-
gramming information
To stop the timer recording in process
Press POWER button first to turn on the unit. Then,
on the front panel of the unit, press STOP C (DVD)
button to stop the recording or C STOP/A EJECT
to stop the tape recording. STOP C button on the
remote control does not work for timer recording.
ENTER
TIMER PROG.
CLEAR
POWER
/ / /
10 Select a recording speed using K/L buttons.
Refer to "Recording speed" on page 48 for DVD
or page 28 for VCR.
• If you set Recording speed to “Auto” at step
[10], this unit will automatically adjust the
recording speed so that the program will fit into
one disc.
(You can select “Auto” in the first program only.)
11
Press ENTER button when all information
required is entered.
Your program setting will be entered.
• To set another program, repeat steps [5] to [11].
• To exit, press SETUP button.
12
Press POWER button to turn off.
Important
When you set the timer program in either DVD
mode or VCR mode, RECORD indicator (DVD)
will illuminate on the front of the TV. See item
No.19 on page 7.
NOTE:
• If power is not turned off and you continue watching TV,
“TIMER REC STANDBY” starts flashing on the TV screen 2
minutes before the programmed start time. In this case,
press POWER button to turn off to activate the timer record-
ing.
• You may turn on the unit once the timer recording has start-
ed.
1H
- - -
JAN/01
Setup > Recording > Timer Programming
Date Start End CH
10:30PM 10:00PM CH8 DVD
DVD VCR
JAN / 1/ 2004 (THU) 12 : 00 PM
Speed
OPERA
TING D
VD RECORDER
TIMER RECORDING
T2020UA_45-LAST 04.8.10 3:41 PM Page 59