Toshiba S20LP - Manual (Page 24)


23

6 F 3 B 0 3 5 6
Select the "Station Number" of the connected S20LP-station. Select the "Scan Transmission" and
specify the "data send block(s)". The "data send block" is specified by entering the starting
address (Send Starting Address 1/2) and the size (Number of Send Words 1/2). Up to two "data
send blocks" can be specified. If "data send block 2" is not used, enter 0 both for Send Starting
Address 2 and Number of Send Words 2. The maximum size of send words is Number of Send
Words 1 and 2, total 1024 words.