Toshiba S20LP - Manual (Page 9)


8

6 F 3 B 0 3 5 6
• Station number setting switches:
Used to set the station number. (allowable setting is 1 to 64)
The setting status is read at power-on.
STNH ................ 10’s digit
STNL ................ 1’s digit
• Loader port:
Used to connect the S-LS (or T-PDS for remote programming / monitoring).
T2N (PU245N) changes DIP switch (P/S) “ON”.
• Transmission cable connector(s):
Used to connect optical fiber cables. (see Section 4)
• Reset switch (only SN325):
Used to reset a SN325.