Toshiba S20LP - Manual (Page 26)


25

6 F 3 B 0 3 5 6
(5) Settings of station control information
Open the "Setting Information", and push the "Station Control" by mouse.
• Scan Transmission
Enable/disable the Scan transmission. Select Enable to use the Scan transmission
function.
• Scan Access
Scan data synchronization 1 word or 2 words. If 2W (2 words) is selected, data
synchronization of double-word data (lower even and higher odd addresses) is achieved.
In this case, 2W setting is needed both on the sender and receiver stations. Also, if 2W is
selected, Send Start Address and Send Word Number must be even number.
• Message Transmission
Enable/disable the Message transmission. The Message transmission is used for S-LS
remote setting/monitoring, T-PDS remote programming, T-series computer link protocol
and PC link protocol. Normally select Enable.
• Start with Standby mode
When this space is not checked, Scan transmission is automatically started at power-up.
When this space is checked, Scan transmission is not started until Online request is issued
by S-LS. Normally no check.