Tektronix 1705A - Manual (Page 97)

Checks and Adjustments
5- 2 1705A Spectrum Monitor
2. Leveled Sine Wave Generator , at least 250 kHz to 95 MHz.
For example: A TEKTRONIX SG503 Leveled Sine Wave Generator
installed in a TEKTRONIX TM500 Series Power Module.
3. Voltmeter
Range, 0 to greater than 100 Vdc; accuracy,
±0.1%.
For example: A TEKTRONIX DM501A in a TM500 Series Power Module.
4. Power Module for powering and housing TEKTRONIX DM501A,
DC503A, FG503, 067-0916-00, and 015-0408-00.
For example: A TEKTRONIX TM506 Power Module.
5. UHF Signal Generator
A frequency range of at least 900 to 1800 MHz, with an amplitude of
--20 dBm, or more, and flatness within 3 dB over the frequency range.
Accurate step attenuator calibrated in dB (0 to --60).
For example: A TEKTRONIX TR502 Tracking Generator and associated
equipment, a Wavetek Model 3520, or a Hewlett Packard 8614A Signal
Generator with 8496A Attenuator/110 dB.
6. Variable Autotransformer
For example: General Radio Metered Auto Transformer W10MT3W. If
220 volt operation must be checked, a conversion transformer or appropriate
220 volt autotransformer is needed.
7. Comb Generator
For example: Tektronix Part No. 015-1054-00.
8. 50
Ω Coaxial Cable
Two required.
For example: Tektronix Part No. 012-0057-01.
9. Bnc Male-to-bnc Male Adapter
For example: Tektronix Part No. 103-0029-00.
10. F-Type Male-to-bnc Female Adapter
For example: Tektronix Part No. 103-0158-00.
Auxiliary Equipment