TP-Link TL-R460 - Manual (Page 48)

TL-R460 Cable/DSL Router User Guide
41
Step 1: Enable the “Firewall” and “IP Address Filtering” on the Firewall screen (show in
Figure 4-27), and then, you should select the Default IP Address Filtering Rule
"Allow the packets not specified by any filtering rules to pass through the
router".
Step 2: Click Add New…/Modify shown in Figure 4-28, you will see a new screen
shown in Figure 4-29.
Step 3: Enter the “Effective time” that the rule will take effect as shown in Figure 4-29.
Step 4: Enter the “LAN IP Address”, “LAN Port”, “WAN IP Address” and “WAN Port” in
the corresponding field as shown in Figure 4-29.
Step 5: Select the “Protocol”, “Action” and “Status” for the rule as shown in the next
screen.
Figure 4-29
Step 6: Click the Save button to save this entry.
Step 7: Go to Step 2 to complete the other rules continually.
After you finish the configurations, you will see the rules in the table below:
Figure 4-30
) Note:
Before adding an IP Address Filtering entry, you should enable the Firewall and the IP
Address Filtering function first (shown in Figure 4-27).