Assembly, Driveshaft & front pump mounting, Adjusting rear wheels – Tiger BENGAL BRUTE JD 62-6420 User Manual
Page 36: Weather-pack/metri-pack assembly
ASSEMBLY
Assembly Section 2-4
DRIVESHAFT & FRONT PUMP MOUNTING
Install spacer plate on tractor engine using bolts and lockwashers as shown in parts section.
Grease sleeve section of the driveshaft and install from the side of the engine compartment.
Once you have the sleeve section in place, bolt to spacer plate using bolts and lockwashers as
shown in parts section. Install shaft end of driveshaft through opening and into driveshaft sleeve.
Shaft and sleeve yokes should be aligned, if shaft does not insert easily in sleeve, turn shaft
180°, and then install. Shaft end must be installed in correct orientation, failure to do so
may result in damage to tractor and/or driveshaft. After installation of shaft end, install pump
mount. Next, install pump. After pump is secured, install driveshaft in to pump shaft. The end of
driveshaft should be no more than 1/2” away from contact with pump housing. Tighten crimping
bolt on driveshaft. Lube driveshaft & check all hoses, flanges, the pump, pump mount, driveshaft
and mounting plate to ensure all fasteners are tightened before operation.
CAUTION: DO NOT START THE TRACTOR UNTIL ALL HOSES ARE ATTACHED, TANK
IS FILLED WITH PROPER OIL AND BALL VALVES ARE OPEN! STARTING AT THIS TIME
WILL CAUSE SERIOUS DAMAGE TO THE PUMP.
(ASM-JD-0216)
ADJUSTING REAR WHEELS
Raise rear of tractor onto jack-stands. Follow the instructions in the tractor owners
manual for adjusting tires and rims. The back wheels MUST be adjusted to the widest
setting. NOTE: This may require switching the wheels to opposite sides of tractor. Also take
note of any width restrictions when transporting by trailer. (For ease of installation, it is best to
leave the rear wheels removed during installation of the mower.)
(ASM-B-0001)
WEATHER-PACK/METRI-PACK ASSEMBLY
These instructions apply to both Weather-Pack and Metri-pack connectors.
NOTE: Use the specific tool for the type of connector you are assembling.
(ASM-C-0009)