Tiger BENGAL BRUTE JD 62-6420 - Manual (Page 47)

ASSEMBLY
Assembly Section 2-15
LOAD SENSE LINE INSTALLATION - MANUAL
(2004 UPDATE)
To install the load sense line from a Husco valve to the tractor remote valve, first locate
the load sense port located on the bottom of the end cap. Remove the plug and install
14mm elbow, then attach the 1/4” hose to the end cap and to the top front port on the
Husco valve.
For more information refer to the Parts Section pages for a complete diagram of the tractor
valve hookup.
(ASM-JD-0215)
2004 UPDATES APPLY TO THESE MODEL’S
JD6000 SERIES SERIAL #’S WITH THIS CHANGE: 391333, 391640, 392239, 395891, 396190, 397161,
396515, 396572, 396560, 396777, 396754, 396764, 396981, 397327, 396983, 396987, 397165, 397159,
397211, 397773, 397450, 397354, 397341, 397498, 397527, 397520, 397360, 397475, 397538, 397569,
397554, 397545, 397585, 397506, 397570, 397587, 397575, AND MODEL #’S STARTING WITH
#398797.
ACCUMULATOR INSTALLATION
Install the accumulator bracket on tab with holes provided on the right main frame or lift valve
mount, if applicable, with the capscrews and lockwashers as shown in the Parts Section. Install
the accumulator in the bracket and secure with the hardware shown. Install fittings and hoses to
the cylinder and control valve as shown in the Parts Section. Use teflon tape on all pipe
fittings (except O-rings).
(ASM-C-0012)