Tiger BENGAL BRUTE JD 62-6420 - Manual (Page 56)

ASSEMBLY
Assembly Section 2-24
WHEEL WEIGHT MOUNTING
For all tractors using a boom mower, a wheel weight will be required for the rear left side
wheel. It will be necessary to mount the weight in the wheel using the long capscrews,
lockwashers, flatwashers, spacers (if applicable), and hex nuts per the diagram in the parts
section.
Installation is most easily done with a fork lift, inserting a fork in the center slot of the wheel
weight. The head of the capscrews is to be toward the OUTSIDE of the weight, with flatwashers
on both the inside and outside of the assembly.
The left rear tire may also be filled with a mixture of water and calcium chloride at about five
pounds per gallon. Tire air pressure should be maintained according to the Maintenance
Section.
(ASM-C-0055)
EXTENDING ZERK ON FLAIL HEAD
Due to the belt shield covering the cutter shaft bearing on the flail head a hose, elbow, &
grease zerk have been added to the bearing. Remove the existing grease zerk from the bearing
and discard. Attach the elbow to the bearing. Next, the hose is attached to the elbow and routed
through the belt shield(shown below) and attached to the outside of the shield. The additional
zerk is connected to the end of the hose for easier bearing maintenance.
After assembling all components, double check the complete assembly from the main
frame to the cutter head. Check the diagrams in the parts sections for proper placement
and assembly of all components.
(ASM-FLAIL-0001)